Separate names with a comma.
Does anyone have the wiring diagram for the amp meter for the 67 shelby rally pac thanks Nick
Does any one have an extra 1967 GT350 or GT500 steering wheel for sale any condition cracked or needing repair thanks Nick
looking for a shelby steering wheel for a 67 does not have to be perfect I will restore it thanks Nick
I was just curious what is the best wheel and tire combination for the 1967. I want to stay with the same wheel and tire size front and back and...
looking to purchase a four speed shifter for a 67 toploader thanks Nick
Help!! what is the proper placement for the fender emblems on the 67 Shelby measurements above the gt stripe and placement as well as the deck...
what is the best rim and tire selection for the 67 gt350? what is the widest tire on a 15 inch rim that will still allow no rubbing? thanks Nick
Does any on have any advice on trimming the two rear interior pannels around the roll bar for a 1967 thanks Nick
Does ANY ONE KNOW WHAT KIND OF SHOULDER HARNESS RETRACTORS THEY USED ON THE 67 GT350 AND 500 I AM SURE THEY PROBABLY ADAPTED THEM FROM SOME OTHER...
Does any one have a good diagram of the tail light wiring on a 1967 GT350 have the standard taillight loom and the cougar tail light loom need to...
Can anyone tell me how to convert a non tach underdash harness to a tach harness thanks Nick
Did any late 67 shelby's or fastbacks come with a steering column with a rag Joint besides a tilt column setup thanks Nick
I posted this before but now I am getting close to completion and I lost the contacts of thoes who responded. I am looking for a steering wheel...
I need help getting the right drive shaft length for a GT 350 with four speed top loader thanks Nick
I know this topic has been brought up before, I am building a GT 350 clone and wanted get your opinion on the stripes. thanks Nick
Any one have an extra deck lid spring for a 1967 for sale or know where I can get one thanks, Nick
Does any one have the correct width measurments for the 1967 shelby GT 350 stripes for the nose, hood, roof and deck lid. and also the correct...
Does any one know if there is an aftermarket 1967 shelby steering wheel available Besides the one offered by Tony Branda for 2500.00 thanks Nick
Hello all, I am new to the site I am building a shelby GT 350 Clone because I don't think I would ever be able to buy a real one. I purchased a...
