Separate names with a comma.
Thanks for the replies. I buy from West Coast Classic Cougar often but they couldn't help on the compressor. I'll try Classic Auto Air...
I'm working on a '69 that's about 80% assembled after partial restoration. Most of the interior is out and I'll have (at least) part of the dash...
If it's any help the car I'm working on is 6/69 and the brackets are welded Cheers DD
On the car I have the black/green wire goes to the o/p gauge. if you were holding the o/p gauge in your hand, looking at the backside, with the...
It so happens the the '69 I'm working on has the console partially removed so maybe this will help..... Under the ashtray is a 2-pin connector...
Resurecting an old thread. I've been waylayed and still haven't finished this aspect of the project. A couple more questions.... 1) Is it...
Ahhhhhhhh. OK. Suddenly it all makes sense. The wires that somebody (not me!) ran to the core support are supposed to go to the lamp mounting...
More info..... You guys probably know all about this but I thought it I'd throw it open for comment. I had an opportunity to compare this...
Ok, thanks for the reply and confirmation that I wasn't losing my marbles. If nobody posts a pic I'll work up a nice sanitary ground. Cheers DD
I'm stumped. Got all the exterior lights working perfectly...even the rear sequential signals.... except the front park/signal lamps. The...
100 Thanks, guys :evo: Cheers DD
Bit by bit I'm getting this car assembled...always a challenge when someone else has disassembled it....heh heh Anyhow, take a peek at the pic....
